side note) when coating with duct make tape use thin strips (normal strips torn in half) around the edges, then cover the larger areas with normal size strips.
Now you can make tape his-and-hers versions with a little bit of washi tape.Start by figuring out your head size.Then cut a strip out, (a little more than an badges make inch tape in length) just short of the top make leaving an inch holding it together.Now hold the face-plate on, adjust it until it lines up with your face, now get someone to draw a line where the face-plate meets the dome.Step 17: Tape the Insides Now duct tape the innards.Share Recommendations Make It Fly Challenge Metal Contest Classroom Organization Challenge 17 Discussions.Most make cant find these, so I'll update this banner when i can make cardboard tape horns its fairly easy, bonus points if you can make them yourself.I got lucky and found these make Styrofoam pieces in an old car seat.Step 13: Begin Taping Start taping the helmet starting make in the four sections between tape the ridges, get in between with thinner strips* (make them by tearing normal strips in half, its easy) then go over the ridges.Add a layer of gray tape first to secure the horns, then go over with thin strips of tan.Now hot glue both of them to the upper sides of the dome, make sure they're level and strait, i recommend gluing them on with a little bit of glue (so you can pull it of easily if you mess up) until they're alined strait.Quickly adjust the horns if needed, the glue can set pretty fast. Washi tape make hair clips, coordinate a plain hair clip with your android outfit for the over day.
Now your done with the cardboard!
Step 15: Back Now get the back.
Duct tape Gray and band tan (optional brown).Washi avatar tape is an inexpensive paper tape that comes in video a wide range of colors and patterns, which makes it the craft supply of choice for both experienced and novice crafters.Measuring tape, materials: Corrugated cardboard (a large box should be enough).Step 14: Now tape over make the face-plate.Now look around the whole helmet to see if there's any cardboard showing, if so, make more duct make tape!Tools: Hot glue gun, cutting mat, exacto knife or other cutting tool.Unscrew your switch plate, cover it with washi tape, and then put it back into place.(credit for this technique goes to Seamster) you'll be using this technique for every piece lay it out flat and cut the spikes out (as strait as possible) and then break the backing of all the spikes so they can curve inward.Step 12: Attaching Horns First make sure the horn fit in the horn mounts.If you have seen washi tape in the stores but wondered what to do with it, we have some great craft ideas to get you started.Cut two pieces of washi tape that are the length of a pencil.Because the tape is made of paper, you won't have any trouble sharpening the pencils as usual.Follow 3 answers.